MERCEDES /AUDI RADIO REMOVAL TOOL PART DM-20-22
Download PART NUMBER: DM-20-22 069803-00 STEP1. Insert the two (2) radio removal tools into the slots on the face of the radio. NOTE: Make sure the two (2) notches on the removal tools are pointed...
View Article1995 Mazda MX-6 BRAKE SYSTEM REMOVAL & INSTALLATION
Download 1. Raise and support front of vehicle. Remove front wheel assemblies. Remove lower lock pin/guide bolt. See Fig. 2 . Pivot caliper upward and support using rope. 2. Remove pads, shims, guide...
View Article1994 Audi S4 Rear Differential – Right and Left Side Seal
Download The following describes the procedure I used to remove and replace the right and left side rear differential seals on my 1994 Audi S4. This procedure should apply to the 1992 – 1994 S4 and the...
View Article2000-2004 Ford Focus ZX3 SVT Suspension Kit INSTALLATION INSTRUCTIONS
DownloadPARTS IN KIT: ITEM # QTY DESCRIPTION SERVICE PART # REPLACEMENT SOURCE 1 2 Spring, rear 2M5Z-5B669-AA Ford Dealer 2 2 Shock, rear 2M5Z-18125-BA Ford Dealer 3 1 Anti-roll bar, rear 1S4Z-5A772-BA...
View Article2000-2001 Audi TT Coupe Compact Disc Changer Installation Instructions
Download Description Part No: Qty CD Changer 8N8 035 111A 1 Installation kit 8N8 051 229A 1 Rear seat, removal – Remove rear seat bottom. – Disconnect left rear seat belt at body anchorage point. –...
View ArticleHonda 250 Recon 2×4 Lift Kit Installation Instructions
Download Front Lift 1) Place jack under center of ATV front end and lift until front wheels clear the ground. Be careful to support ATV properly so that it is securely supported but so that A-arms and...
View Article2000-2002 Audi Quattro StartupRacing Contest and Competition Suspension...
Download B5 Audi Quattro (2000-2002 Audi S4 and 1996-2001 Audi A4). Suspension Removal General 1. Loose wheel bolts 2. Raise the car and support it with two or four jack stands (if only using two,...
View Article2007 Toyota Camry Rear Bumper Removal and Replacement
Download REMOVAL 1. REMOVE REAR BUMPER ASSEMBLY (w/o Rear Lower Spoiler ) a. Put protective tape around the rear bumper assembly. b. Using a screwdriver, open the 2 rear bumper plates. HINT: Tape the...
View ArticleHONDA ST1100 SHOCK MOUNTING INSTALLATION INSTRUCTIONS
Download CAUTION: This shock is pressurized to 250 psi nitrogen. The pressure is not an adjustable feature of the shock. Unless the reservoir bladder assembly leaks, the shock should not normally lose...
View Article1997 Taurus/Sable Shock Absorber Strut Assembly
Download 1. CAUTION: Do not raise vehicle by rear suspension tension strut and bushing (5A952). Damage to strut may result. Raise hoist or jack only enough to contact body. Refer to Section 00-02 . 2....
View Article